Wiphy phy1 wiphy index: 1 max # scan SSIDs: 9 max scan IEs length: 2304 bytes max # sched scan SSIDs: 0 max # match sets: 0 Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Supported Ciphers: * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * TKIP (00-0f-ac:2) * CCMP-128 (00-0f-ac:4) * CMAC (00-0f-ac:6) Available Antennas: TX 0 RX 0 Supported interface modes: * IBSS * managed * AP * P2P-client * P2P-GO Band 2: Bitrates (non-HT): * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 5180 MHz [36] (30.0 dBm) * 5200 MHz [40] (30.0 dBm) * 5220 MHz [44] (30.0 dBm) * 5240 MHz [48] (30.0 dBm) * 5260 MHz [52] (30.0 dBm) (radar detection) * 5280 MHz [56] (30.0 dBm) (radar detection) * 5300 MHz [60] (30.0 dBm) (radar detection) * 5320 MHz [64] (30.0 dBm) (radar detection) * 5500 MHz [100] (30.0 dBm) (radar detection) * 5520 MHz [104] (30.0 dBm) (radar detection) * 5540 MHz [108] (30.0 dBm) (radar detection) * 5560 MHz [112] (30.0 dBm) (radar detection) * 5580 MHz [116] (30.0 dBm) (radar detection) * 5600 MHz [120] (30.0 dBm) (radar detection) * 5620 MHz [124] (30.0 dBm) (radar detection) * 5640 MHz [128] (30.0 dBm) (radar detection) * 5660 MHz [132] (30.0 dBm) (radar detection) * 5680 MHz [136] (30.0 dBm) (radar detection) * 5700 MHz [140] (30.0 dBm) (radar detection) * 5720 MHz [144] (disabled) * 5745 MHz [149] (30.0 dBm) * 5765 MHz [153] (30.0 dBm) * 5785 MHz [157] (30.0 dBm) * 5805 MHz [161] (30.0 dBm) * 5825 MHz [165] (30.0 dBm) * 5845 MHz [169] (disabled) * 5865 MHz [173] (disabled) * 5885 MHz [177] (disabled) Supported commands: * new_interface * set_interface * new_key * start_ap * new_station * set_bss * join_ibss * set_pmksa * del_pmksa * flush_pmksa * remain_on_channel * frame * set_wiphy_netns * set_channel * connect * disconnect WoWLAN support: * wake up on anything (device continues operating normally) software interface modes (can always be added): interface combinations are not supported Device supports SAE with AUTHENTICATE command Device supports scan flush. max # scan plans: 1 max scan plan interval: -1 max scan plan iterations: 0 Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0xd0 * managed: 0x40 0xb0 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 Supported extended features: