Probe #07dfc865cf of HP ProBook 450 G0

Log: smartctl

/dev/sda smartctl 7.3 2022-02-28 r5338 [x86_64-linux-5.19.4-arch1-1] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Scorpio Blue Serial ATA (AF) Device Model: WDC WD7500BPVT-60HXZT3 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 750,156,374,016 bytes [750 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database 7.3/5319 ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Thu Sep 8 08:36:33 2022 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 33) The self-test routine was interrupted by the host with a hard or soft reset. Total time to complete Offline data collection: (16380) seconds. Offline data collection capabilities: (0x51) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 161) minutes. SCT capabilities: (0x703d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 177 175 021 - 2133 4 Start_Stop_Count -O--CK 094 094 000 - 6329 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate POSR-K 200 200 051 - 0 9 Power_On_Hours -O--CK 085 085 000 - 11185 10 Spin_Retry_Count PO--CK 100 100 051 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 094 094 000 - 6298 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O---K 062 057 040 - 38 (Min/Max 38/38) 191 G-Sense_Error_Rate -O--CK 001 001 000 - 2746 192 Power-Off_Retract_Count -O--CK 200 200 000 - 216 193 Load_Cycle_Count -O--CK 001 001 000 - 1706293 194 Temperature_Celsius -O---K 109 104 000 - 38 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate P--R-- 100 253 051 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Interrupted (host reset) 10% 6001 - # 2 Short offline Completed without error 00% 3435 - # 3 Short offline Completed without error 00% 3415 - # 4 Short offline Completed without error 00% 3405 - # 5 Short offline Completed without error 00% 3395 - # 6 Short offline Completed without error 00% 3370 - # 7 Short offline Completed without error 00% 3354 - # 8 Short offline Completed without error 00% 3341 - # 9 Short offline Completed without error 00% 3312 - #10 Short offline Completed without error 00% 3282 - #11 Short offline Completed without error 00% 3255 - #12 Short offline Completed without error 00% 3236 - #13 Short offline Completed without error 00% 3187 - #14 Short offline Completed without error 00% 3115 - #15 Short offline Completed without error 00% 3086 - #16 Short offline Completed without error 00% 3063 - #17 Short offline Completed without error 00% 3043 - #18 Short offline Completed without error 00% 3019 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 38 Celsius Power Cycle Min/Max Temperature: 38/38 Celsius Lifetime Min/Max Temperature: 0/43 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (63) Index Estimated Time Temperature Celsius 64 2022-09-08 06:29 39 ******************** ... ..( 10 skipped). .. ******************** 75 2022-09-08 06:40 39 ******************** 76 2022-09-08 06:41 38 ******************* ... ..( 50 skipped). .. ******************* 127 2022-09-08 07:32 38 ******************* 0 2022-09-08 07:33 ? - 1 2022-09-08 07:34 26 ******* 2 2022-09-08 07:35 27 ******** 3 2022-09-08 07:36 27 ******** 4 2022-09-08 07:37 27 ******** 5 2022-09-08 07:38 28 ********* 6 2022-09-08 07:39 29 ********** 7 2022-09-08 07:40 30 *********** 8 2022-09-08 07:41 30 *********** 9 2022-09-08 07:42 32 ************* 10 2022-09-08 07:43 31 ************ 11 2022-09-08 07:44 32 ************* 12 2022-09-08 07:45 33 ************** 13 2022-09-08 07:46 33 ************** 14 2022-09-08 07:47 33 ************** 15 2022-09-08 07:48 34 *************** 16 2022-09-08 07:49 34 *************** 17 2022-09-08 07:50 35 **************** ... ..( 2 skipped). .. **************** 20 2022-09-08 07:53 35 **************** 21 2022-09-08 07:54 ? - 22 2022-09-08 07:55 28 ********* 23 2022-09-08 07:56 29 ********** 24 2022-09-08 07:57 30 *********** 25 2022-09-08 07:58 31 ************ 26 2022-09-08 07:59 31 ************ 27 2022-09-08 08:00 32 ************* 28 2022-09-08 08:01 32 ************* 29 2022-09-08 08:02 33 ************** 30 2022-09-08 08:03 34 *************** 31 2022-09-08 08:04 34 *************** 32 2022-09-08 08:05 35 **************** ... ..( 3 skipped). .. **************** 36 2022-09-08 08:09 35 **************** 37 2022-09-08 08:10 36 ***************** 38 2022-09-08 08:11 36 ***************** 39 2022-09-08 08:12 36 ***************** 40 2022-09-08 08:13 37 ****************** 41 2022-09-08 08:14 37 ****************** 42 2022-09-08 08:15 37 ****************** 43 2022-09-08 08:16 38 ******************* ... ..( 5 skipped). .. ******************* 49 2022-09-08 08:22 38 ******************* 50 2022-09-08 08:23 39 ******************** ... ..( 3 skipped). .. ******************** 54 2022-09-08 08:27 39 ******************** 55 2022-09-08 08:28 40 ********************* ... ..( 2 skipped). .. ********************* 58 2022-09-08 08:31 40 ********************* 59 2022-09-08 08:32 ? - 60 2022-09-08 08:33 38 ******************* ... ..( 2 skipped). .. ******************* 63 2022-09-08 08:36 38 ******************* SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 24 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 266 Vendor specific


Hardware for Linux and BSD

GitHub