/dev/sda smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.2.10-arch1-1] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Blue Mobile (SMR) Device Model: WDC WD10SPZX-60Z10T0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 04.01A04 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches TRIM Command: Available, deterministic Device is: In smartctl database 7.3/5319 ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Fri Apr 14 22:26:25 2023 +00 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 840) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 267) minutes. SCT capabilities: (0x303d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 32 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 100 050 - 2 3 Spin_Up_Time POS--K 057 053 021 - 1291 4 Start_Stop_Count -O--CK 100 100 000 - 43463 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 7 Seek_Error_Rate POSR-K 100 100 030 - 30499 9 Power_On_Hours -O--CK 100 100 000 - 7985 10 Spin_Retry_Count PO--CK 100 100 050 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 3214 183 Runtime_Bad_Block -O--CK 100 100 000 - 224539 184 End-to-End_Error PO-RCK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 100 000 - 596 189 High_Fly_Writes -O-RCK 100 100 000 - 0 191 G-Sense_Error_Rate -O--CK 001 001 000 - 18509 192 Power-Off_Retract_Count -O--CK 100 100 000 - 622770258065 193 Load_Cycle_Count -O--CK 023 023 000 - 155160 194 Temperature_Celsius -O---K 033 052 000 - 33 (Min/Max 24/33) 197 Current_Pending_Sector -O--CK 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -O--CK 100 100 000 - 3 200 Multi_Zone_Error_Rate ---R-- 100 253 000 - 0 240 Head_Flying_Hours -O--CK 100 100 000 - 2124467 243 Unknown_Attribute -O--CK 100 100 000 - 19313025 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x24 GPL R/O 288 Current Device Internal Status Data log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb6 GPL,SL VS 1 Device vendor specific log 0xb7 GPL,SL VS 74 Device vendor specific log 0xb9 GPL,SL VS 4 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 33 Celsius Power Cycle Min/Max Temperature: 24/33 Celsius Lifetime Min/Max Temperature: 13/52 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (97) Index Estimated Time Temperature Celsius 98 2023-04-14 20:19 31 ************ ... ..( 29 skipped). .. ************ 0 2023-04-14 20:49 31 ************ 1 2023-04-14 20:50 32 ************* ... ..( 11 skipped). .. ************* 13 2023-04-14 21:02 32 ************* 14 2023-04-14 21:03 31 ************ 15 2023-04-14 21:04 32 ************* ... ..( 7 skipped). .. ************* 23 2023-04-14 21:12 32 ************* 24 2023-04-14 21:13 33 ************** 25 2023-04-14 21:14 33 ************** 26 2023-04-14 21:15 33 ************** 27 2023-04-14 21:16 35 **************** 28 2023-04-14 21:17 34 *************** ... ..( 4 skipped). .. *************** 33 2023-04-14 21:22 34 *************** 34 2023-04-14 21:23 35 **************** 35 2023-04-14 21:24 36 ***************** 36 2023-04-14 21:25 35 **************** 37 2023-04-14 21:26 35 **************** 38 2023-04-14 21:27 35 **************** 39 2023-04-14 21:28 36 ***************** 40 2023-04-14 21:29 36 ***************** 41 2023-04-14 21:30 35 **************** ... ..( 3 skipped). .. **************** 45 2023-04-14 21:34 35 **************** 46 2023-04-14 21:35 34 *************** ... ..( 9 skipped). .. *************** 56 2023-04-14 21:45 34 *************** 57 2023-04-14 21:46 ? - 58 2023-04-14 21:47 24 ***** 59 2023-04-14 21:48 25 ****** 60 2023-04-14 21:49 26 ******* 61 2023-04-14 21:50 28 ********* ... ..( 3 skipped). .. ********* 65 2023-04-14 21:54 28 ********* 66 2023-04-14 21:55 29 ********** 67 2023-04-14 21:56 30 *********** 68 2023-04-14 21:57 30 *********** 69 2023-04-14 21:58 31 ************ ... ..( 16 skipped). .. ************ 86 2023-04-14 22:15 31 ************ 87 2023-04-14 22:16 32 ************* 88 2023-04-14 22:17 31 ************ 89 2023-04-14 22:18 31 ************ 90 2023-04-14 22:19 31 ************ 91 2023-04-14 22:20 32 ************* ... ..( 3 skipped). .. ************* 95 2023-04-14 22:24 32 ************* 96 2023-04-14 22:25 33 ************** 97 2023-04-14 22:26 33 ************** SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 4 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 5 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 2373 Vendor specific