/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-58-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: HGST Travelstar 5K1000 Device Model: HGST HTS541010A9E680 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JA0OA710 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sun Jan 22 12:48:52 2023 EET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 217) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 099 062 - 0 2 Throughput_Performance P-S--K 100 100 040 - 0 3 Spin_Up_Time PO---K 185 100 033 - 1 4 Start_Stop_Count -O--CK 099 099 000 - 1939 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate POSR-K 100 100 067 - 0 8 Seek_Time_Performance P-S--K 100 100 040 - 0 9 Power_On_Hours -O--CK 093 093 000 - 3254 10 Spin_Retry_Count PO--CK 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 1787 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 8590000128 188 Command_Timeout -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O---K 072 053 045 - 28 (Min/Max 19/28) 191 G-Sense_Error_Rate -O--CK 100 100 000 - 177 192 Power-Off_Retract_Count -O--CK 100 100 000 - 2097184 193 Load_Cycle_Count -O--CK 097 097 000 - 35729 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O--CK 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 100 100 000 - 0 223 Load_Retry_Count -O-R-K 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1085 - # 2 Short offline Completed without error 00% 947 - # 3 Short offline Completed without error 00% 870 - # 4 Short offline Completed without error 00% 865 - # 5 Short offline Completed without error 00% 838 - # 6 Short offline Completed without error 00% 807 - # 7 Short offline Completed without error 00% 790 - # 8 Short offline Completed without error 00% 732 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 28 Celsius Power Cycle Min/Max Temperature: 19/28 Celsius Lifetime Min/Max Temperature: 13/47 Celsius Specified Max Operating Temperature: 30 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (35) Index Estimated Time Temperature Celsius 36 2023-01-22 10:41 26 ******* 37 2023-01-22 10:42 26 ******* 38 2023-01-22 10:43 27 ******** ... ..( 3 skipped). .. ******** 42 2023-01-22 10:47 27 ******** 43 2023-01-22 10:48 28 ********* 44 2023-01-22 10:49 27 ******** 45 2023-01-22 10:50 27 ******** 46 2023-01-22 10:51 27 ******** 47 2023-01-22 10:52 28 ********* 48 2023-01-22 10:53 28 ********* 49 2023-01-22 10:54 27 ******** 50 2023-01-22 10:55 28 ********* ... ..( 3 skipped). .. ********* 54 2023-01-22 10:59 28 ********* 55 2023-01-22 11:00 29 ********** 56 2023-01-22 11:01 29 ********** 57 2023-01-22 11:02 29 ********** 58 2023-01-22 11:03 28 ********* ... ..( 6 skipped). .. ********* 65 2023-01-22 11:10 28 ********* 66 2023-01-22 11:11 27 ******** 67 2023-01-22 11:12 27 ******** 68 2023-01-22 11:13 27 ******** 69 2023-01-22 11:14 28 ********* 70 2023-01-22 11:15 27 ******** ... ..( 52 skipped). .. ******** 123 2023-01-22 12:08 27 ******** 124 2023-01-22 12:09 26 ******* 125 2023-01-22 12:10 27 ******** ... ..( 13 skipped). .. ******** 11 2023-01-22 12:24 27 ******** 12 2023-01-22 12:25 ? - 13 2023-01-22 12:26 27 ******** 14 2023-01-22 12:27 ? - 15 2023-01-22 12:28 20 * 16 2023-01-22 12:29 21 ** 17 2023-01-22 12:30 22 *** 18 2023-01-22 12:31 22 *** 19 2023-01-22 12:32 23 **** 20 2023-01-22 12:33 24 ***** 21 2023-01-22 12:34 24 ***** 22 2023-01-22 12:35 25 ****** ... ..( 2 skipped). .. ****** 25 2023-01-22 12:38 25 ****** 26 2023-01-22 12:39 26 ******* 27 2023-01-22 12:40 26 ******* 28 2023-01-22 12:41 26 ******* 29 2023-01-22 12:42 27 ******** ... ..( 4 skipped). .. ******** 34 2023-01-22 12:47 27 ******** 35 2023-01-22 12:48 28 ********* SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 4 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS