/dev/sda smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.6.6-300.fc32.x86_64] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z7K500 Device Model: HGST HTS725050A7E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GH2ZB550 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Fri Oct 16 08:52:40 2020 IST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: ENABLED, PW level MAX, not locked, frozen [SEC6] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 93) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 222 222 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 2280 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 073 073 000 - 12085 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 2279 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 4294901835 193 Load_Cycle_Count -O--C- 063 063 000 - 373091 194 Temperature_Celsius -O---- 157 157 000 - 38 (Min/Max 19/57) 196 Reallocated_Event_Count -O--CK 100 100 000 - 6 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Vendor (0x50) Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 38 Celsius Power Cycle Min/Max Temperature: 21/38 Celsius Lifetime Min/Max Temperature: 19/57 Celsius Specified Max Operating Temperature: 36 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (84) Index Estimated Time Temperature Celsius 85 2020-10-16 06:45 38 ******************* ... ..( 8 skipped). .. ******************* 94 2020-10-16 06:54 38 ******************* 95 2020-10-16 06:55 ? - 96 2020-10-16 06:56 33 ************** ... ..( 3 skipped). .. ************** 100 2020-10-16 07:00 33 ************** 101 2020-10-16 07:01 34 *************** ... ..( 8 skipped). .. *************** 110 2020-10-16 07:10 34 *************** 111 2020-10-16 07:11 35 **************** ... ..( 11 skipped). .. **************** 123 2020-10-16 07:23 35 **************** 124 2020-10-16 07:24 36 ***************** 125 2020-10-16 07:25 35 **************** 126 2020-10-16 07:26 36 ***************** ... ..( 9 skipped). .. ***************** 8 2020-10-16 07:36 36 ***************** 9 2020-10-16 07:37 37 ****************** 10 2020-10-16 07:38 36 ***************** 11 2020-10-16 07:39 37 ****************** 12 2020-10-16 07:40 37 ****************** 13 2020-10-16 07:41 36 ***************** 14 2020-10-16 07:42 37 ****************** ... ..( 10 skipped). .. ****************** 25 2020-10-16 07:53 37 ****************** 26 2020-10-16 07:54 ? - 27 2020-10-16 07:55 22 *** 28 2020-10-16 07:56 23 **** 29 2020-10-16 07:57 24 ***** 30 2020-10-16 07:58 25 ****** 31 2020-10-16 07:59 26 ******* 32 2020-10-16 08:00 27 ******** 33 2020-10-16 08:01 27 ******** 34 2020-10-16 08:02 28 ********* 35 2020-10-16 08:03 28 ********* 36 2020-10-16 08:04 28 ********* 37 2020-10-16 08:05 29 ********** ... ..( 4 skipped). .. ********** 42 2020-10-16 08:10 29 ********** 43 2020-10-16 08:11 30 *********** 44 2020-10-16 08:12 30 *********** 45 2020-10-16 08:13 30 *********** 46 2020-10-16 08:14 31 ************ ... ..( 3 skipped). .. ************ 50 2020-10-16 08:18 31 ************ 51 2020-10-16 08:19 32 ************* ... ..( 2 skipped). .. ************* 54 2020-10-16 08:22 32 ************* 55 2020-10-16 08:23 33 ************** ... ..( 5 skipped). .. ************** 61 2020-10-16 08:29 33 ************** 62 2020-10-16 08:30 34 *************** ... ..( 7 skipped). .. *************** 70 2020-10-16 08:38 34 *************** 71 2020-10-16 08:39 35 **************** ... ..( 4 skipped). .. **************** 76 2020-10-16 08:44 35 **************** 77 2020-10-16 08:45 36 ***************** ... ..( 2 skipped). .. ***************** 80 2020-10-16 08:48 36 ***************** 81 2020-10-16 08:49 37 ****************** 82 2020-10-16 08:50 37 ****************** 83 2020-10-16 08:51 38 ******************* 84 2020-10-16 08:52 38 ******************* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 65535+ Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS