/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.12.12-1-siduction-amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Hitachi/HGST Travelstar Z7K500 Device Model: HGST HTS725050A7E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GS2OA3C0 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Thu Jun 24 12:15:00 2021 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 5036) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 86) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 100 100 062 - 0 2 Throughput_Performance P-S--K 198 100 040 - 97 3 Spin_Up_Time PO---K 253 100 033 - 1 4 Start_Stop_Count -O--CK 100 100 000 - 785 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate POSR-K 100 100 067 - 0 8 Seek_Time_Performance P-S--K 124 100 040 - 53 9 Power_On_Hours -O--CK 069 069 000 - 13598 10 Spin_Retry_Count PO--CK 100 100 060 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 757 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 097 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 34359738368 188 Command_Timeout -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O---K 064 055 045 - 36 (Min/Max 30/42) 191 G-Sense_Error_Rate -O--CK 100 100 000 - 63 192 Power-Off_Retract_Count -O--CK 100 100 000 - 4522053 193 Load_Cycle_Count -O--CK 032 032 000 - 686442 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O--CK 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 100 100 000 - 0 223 Load_Retry_Count -O-R-K 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 13207 - # 2 Short offline Completed without error 00% 12926 - # 3 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: SMART Off-line Data Collection executing in background (4) Current Temperature: 37 Celsius Power Cycle Min/Max Temperature: 30/42 Celsius Lifetime Min/Max Temperature: 15/45 Celsius Specified Max Operating Temperature: 31 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (12) Index Estimated Time Temperature Celsius 13 2021-06-24 10:08 37 ****************** ... ..( 4 skipped). .. ****************** 18 2021-06-24 10:13 37 ****************** 19 2021-06-24 10:14 36 ***************** 20 2021-06-24 10:15 37 ****************** 21 2021-06-24 10:16 36 ***************** 22 2021-06-24 10:17 37 ****************** 23 2021-06-24 10:18 36 ***************** ... ..( 37 skipped). .. ***************** 61 2021-06-24 10:56 36 ***************** 62 2021-06-24 10:57 37 ****************** 63 2021-06-24 10:58 36 ***************** 64 2021-06-24 10:59 36 ***************** 65 2021-06-24 11:00 37 ****************** 66 2021-06-24 11:01 36 ***************** 67 2021-06-24 11:02 36 ***************** 68 2021-06-24 11:03 37 ****************** 69 2021-06-24 11:04 36 ***************** ... ..( 4 skipped). .. ***************** 74 2021-06-24 11:09 36 ***************** 75 2021-06-24 11:10 37 ****************** 76 2021-06-24 11:11 36 ***************** 77 2021-06-24 11:12 37 ****************** 78 2021-06-24 11:13 36 ***************** ... ..( 38 skipped). .. ***************** 117 2021-06-24 11:52 36 ***************** 118 2021-06-24 11:53 37 ****************** 119 2021-06-24 11:54 36 ***************** 120 2021-06-24 11:55 37 ****************** 121 2021-06-24 11:56 36 ***************** ... ..( 4 skipped). .. ***************** 126 2021-06-24 12:01 36 ***************** 127 2021-06-24 12:02 37 ****************** 0 2021-06-24 12:03 36 ***************** 1 2021-06-24 12:04 37 ****************** 2 2021-06-24 12:05 36 ***************** 3 2021-06-24 12:06 36 ***************** 4 2021-06-24 12:07 36 ***************** 5 2021-06-24 12:08 37 ****************** 6 2021-06-24 12:09 37 ****************** 7 2021-06-24 12:10 36 ***************** 8 2021-06-24 12:11 37 ****************** 9 2021-06-24 12:12 37 ****************** 10 2021-06-24 12:13 36 ***************** 11 2021-06-24 12:14 37 ****************** 12 2021-06-24 12:15 37 ****************** SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS