/dev/sda === START OF INFORMATION SECTION === Device Model: Hitachi HTS541010A9E680 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JA0OA480 User Capacity: 1 000 204 886 016 bytes [1,00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Thu Sep 15 21:57:25 2016 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 219) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 198 198 040 - 120 3 Spin_Up_Time POS--- 189 189 033 - 1 4 Start_Stop_Count -O--C- 099 099 000 - 1850 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 115 115 040 - 34 9 Power_On_Hours -O--C- 094 094 000 - 2982 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 1820 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 099 099 000 - 1835282 193 Load_Cycle_Count -O--C- 092 092 000 - 84917 194 Temperature_Celsius -O---- 181 181 000 - 33 (Min/Max 12/58) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 2822 - # 2 Short offline Completed without error 00% 2800 - # 3 Short offline Completed without error 00% 2786 - # 4 Short offline Completed without error 00% 2767 - # 5 Short offline Completed without error 00% 2748 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 33 Celsius Power Cycle Min/Max Temperature: 21/33 Celsius Lifetime Min/Max Temperature: 12/58 Celsius Lifetime Average Temperature: 36 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (20) Index Estimated Time Temperature Celsius 21 2016-09-15 19:50 37 ****************** ... ..( 48 skipped). .. ****************** 70 2016-09-15 20:39 37 ****************** 71 2016-09-15 20:40 38 ******************* 72 2016-09-15 20:41 39 ******************** 73 2016-09-15 20:42 39 ******************** 74 2016-09-15 20:43 39 ******************** 75 2016-09-15 20:44 40 ********************* 76 2016-09-15 20:45 40 ********************* 77 2016-09-15 20:46 40 ********************* 78 2016-09-15 20:47 41 ********************** ... ..( 3 skipped). .. ********************** 82 2016-09-15 20:51 41 ********************** 83 2016-09-15 20:52 42 *********************** 84 2016-09-15 20:53 42 *********************** 85 2016-09-15 20:54 42 *********************** 86 2016-09-15 20:55 43 ************************ ... ..( 7 skipped). .. ************************ 94 2016-09-15 21:03 43 ************************ 95 2016-09-15 21:04 42 *********************** ... ..( 2 skipped). .. *********************** 98 2016-09-15 21:07 42 *********************** 99 2016-09-15 21:08 41 ********************** ... ..( 2 skipped). .. ********************** 102 2016-09-15 21:11 41 ********************** 103 2016-09-15 21:12 40 ********************* ... ..( 2 skipped). .. ********************* 106 2016-09-15 21:15 40 ********************* 107 2016-09-15 21:16 41 ********************** 108 2016-09-15 21:17 ? - 109 2016-09-15 21:18 22 *** 110 2016-09-15 21:19 23 **** 111 2016-09-15 21:20 23 **** 112 2016-09-15 21:21 24 ***** 113 2016-09-15 21:22 26 ******* 114 2016-09-15 21:23 26 ******* 115 2016-09-15 21:24 27 ******** 116 2016-09-15 21:25 27 ******** 117 2016-09-15 21:26 27 ******** 118 2016-09-15 21:27 28 ********* ... ..( 2 skipped). .. ********* 121 2016-09-15 21:30 28 ********* 122 2016-09-15 21:31 29 ********** 123 2016-09-15 21:32 28 ********* 124 2016-09-15 21:33 29 ********** ... ..( 2 skipped). .. ********** 127 2016-09-15 21:36 29 ********** 0 2016-09-15 21:37 30 *********** ... ..( 2 skipped). .. *********** 3 2016-09-15 21:40 30 *********** 4 2016-09-15 21:41 31 ************ ... ..( 4 skipped). .. ************ 9 2016-09-15 21:46 31 ************ 10 2016-09-15 21:47 32 ************* 11 2016-09-15 21:48 31 ************ 12 2016-09-15 21:49 32 ************* ... ..( 6 skipped). .. ************* 19 2016-09-15 21:56 32 ************* 20 2016-09-15 21:57 33 ************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 65535+ Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS