Probe #9ce42e1b01 of ASUSTek UX303LN
Log: smartctl
/dev/sda
smartctl 7.3 2022-02-28 r5338 [x86_64-linux-5.18.3-arch1-1] (local build)
Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: HGST Travelstar Z5K1000
Device Model: HGST HTS541010A7E630
Serial Number: --
LU WWN Device Id: 5 000cca ...
Firmware Version: SE0OA4A0
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 5400 rpm
Form Factor: 2.5 inches
Device is: In smartctl database 7.3/5319
ATA Version is: ATA8-ACS T13/1699-D revision 6
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Sun Jun 12 22:59:55 2022 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
AAM feature is: Unavailable
APM level is: 1 (minimum power consumption with standby)
Rd look-ahead is: Enabled
Write cache is: Enabled
DSN feature is: Unavailable
ATA Security is: Disabled, frozen [SEC2]
Wt Cache Reorder: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 45) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 218) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0
2 Throughput_Performance P-S--- 100 100 040 - 0
3 Spin_Up_Time POS--- 180 180 033 - 1
4 Start_Stop_Count -O--C- 087 087 000 - 20541
5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0
7 Seek_Error_Rate PO-R-- 100 100 067 - 0
8 Seek_Time_Performance P-S--- 100 100 040 - 0
9 Power_On_Hours -O--C- 096 096 000 - 1948
10 Spin_Retry_Count PO--C- 100 100 060 - 0
12 Power_Cycle_Count -O--CK 097 097 000 - 5708
191 G-Sense_Error_Rate -O-R-- 094 094 000 - 1048587
192 Power-Off_Retract_Count -O--CK 100 100 000 - 27
193 Load_Cycle_Count -O--C- 091 091 000 - 96934
194 Temperature_Celsius -O---- 162 162 000 - 37 (Min/Max 13/45)
196 Reallocated_Event_Count -O--CK 100 100 000 - 0
197 Current_Pending_Sector -O---K 100 100 000 - 0
198 Offline_Uncorrectable ---R-- 100 100 000 - 0
199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0
223 Load_Retry_Count -O-R-- 100 100 000 - 0
||||||_ K auto-keep
|||||__ C event count
||||___ R error rate
|||____ S speed/performance
||_____ O updated online
|______ P prefailure warning
General Purpose Log Directory Version 1
SMART Log Directory Version 1 [multi-sector log support]
Address Access R/W Size Description
0x00 GPL,SL R/O 1 Log Directory
0x01 SL R/O 1 Summary SMART error log
0x02 SL R/O 1 Comprehensive SMART error log
0x03 GPL R/O 1 Ext. Comprehensive SMART error log
0x06 SL R/O 1 SMART self-test log
0x07 GPL R/O 1 Extended self-test log
0x09 SL R/W 1 Selective self-test log
0x10 GPL R/O 1 NCQ Command Error log
0x11 GPL R/O 1 SATA Phy Event Counters log
0x80-0x9f GPL,SL R/W 16 Host vendor specific log
0xe0 GPL,SL R/W 1 SCT Command/Status
0xe1 GPL,SL R/W 1 SCT Data Transfer
SMART Extended Comprehensive Error Log Version: 1 (1 sectors)
No Errors Logged
SMART Extended Self-test Log Version: 1 (1 sectors)
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
SCT Status Version: 3
SCT Version (vendor specific): 256 (0x0100)
Device State: Active (0)
Current Temperature: 37 Celsius
Power Cycle Min/Max Temperature: 29/38 Celsius
Lifetime Min/Max Temperature: 13/45 Celsius
Specified Max Operating Temperature: 33 Celsius
Under/Over Temperature Limit Count: 0/0
SCT Temperature History Version: 2
Temperature Sampling Period: 1 minute
Temperature Logging Interval: 1 minute
Min/Max recommended Temperature: 0/60 Celsius
Min/Max Temperature Limit: -40/65 Celsius
Temperature History Size (Index): 128 (103)
Index Estimated Time Temperature Celsius
104 2022-06-12 20:52 39 ********************
105 2022-06-12 20:53 ? -
106 2022-06-12 20:54 27 ********
107 2022-06-12 20:55 27 ********
108 2022-06-12 20:56 29 **********
109 2022-06-12 20:57 29 **********
110 2022-06-12 20:58 29 **********
111 2022-06-12 20:59 31 ************
112 2022-06-12 21:00 30 ***********
113 2022-06-12 21:01 31 ************
114 2022-06-12 21:02 31 ************
115 2022-06-12 21:03 31 ************
116 2022-06-12 21:04 32 *************
117 2022-06-12 21:05 32 *************
118 2022-06-12 21:06 33 **************
119 2022-06-12 21:07 33 **************
120 2022-06-12 21:08 33 **************
121 2022-06-12 21:09 34 ***************
... ..( 2 skipped). .. ***************
124 2022-06-12 21:12 34 ***************
125 2022-06-12 21:13 35 ****************
126 2022-06-12 21:14 35 ****************
127 2022-06-12 21:15 36 *****************
0 2022-06-12 21:16 35 ****************
1 2022-06-12 21:17 36 *****************
2 2022-06-12 21:18 36 *****************
3 2022-06-12 21:19 36 *****************
4 2022-06-12 21:20 37 ******************
... ..( 9 skipped). .. ******************
14 2022-06-12 21:30 37 ******************
15 2022-06-12 21:31 38 *******************
16 2022-06-12 21:32 38 *******************
17 2022-06-12 21:33 38 *******************
18 2022-06-12 21:34 39 ********************
19 2022-06-12 21:35 40 *********************
... ..( 6 skipped). .. *********************
26 2022-06-12 21:42 40 *********************
27 2022-06-12 21:43 39 ********************
... ..( 12 skipped). .. ********************
40 2022-06-12 21:56 39 ********************
41 2022-06-12 21:57 40 *********************
... ..( 5 skipped). .. *********************
47 2022-06-12 22:03 40 *********************
48 2022-06-12 22:04 39 ********************
... ..( 4 skipped). .. ********************
53 2022-06-12 22:09 39 ********************
54 2022-06-12 22:10 40 *********************
... ..( 3 skipped). .. *********************
58 2022-06-12 22:14 40 *********************
59 2022-06-12 22:15 41 **********************
60 2022-06-12 22:16 41 **********************
61 2022-06-12 22:17 ? -
62 2022-06-12 22:18 27 ********
63 2022-06-12 22:19 28 *********
64 2022-06-12 22:20 29 **********
65 2022-06-12 22:21 ? -
66 2022-06-12 22:22 31 ************
67 2022-06-12 22:23 32 *************
68 2022-06-12 22:24 32 *************
69 2022-06-12 22:25 33 **************
70 2022-06-12 22:26 33 **************
71 2022-06-12 22:27 34 ***************
72 2022-06-12 22:28 34 ***************
73 2022-06-12 22:29 34 ***************
74 2022-06-12 22:30 35 ****************
75 2022-06-12 22:31 35 ****************
76 2022-06-12 22:32 36 *****************
... ..( 5 skipped). .. *****************
82 2022-06-12 22:38 36 *****************
83 2022-06-12 22:39 37 ******************
84 2022-06-12 22:40 36 *****************
... ..( 2 skipped). .. *****************
87 2022-06-12 22:43 36 *****************
88 2022-06-12 22:44 37 ******************
... ..( 14 skipped). .. ******************
103 2022-06-12 22:59 37 ******************
SCT Error Recovery Control:
Read: Disabled
Write: Disabled
Device Statistics (GP/SMART Log 0x04) not supported
Pending Defects log (GP Log 0x0c) not supported
SATA Phy Event Counters (GP Log 0x11)
ID Size Value Description
0x0001 2 0 Command failed due to ICRC error
0x0002 2 0 R_ERR response for data FIS
0x0003 2 0 R_ERR response for device-to-host data FIS
0x0004 2 0 R_ERR response for host-to-device data FIS
0x0005 2 0 R_ERR response for non-data FIS
0x0006 2 0 R_ERR response for device-to-host non-data FIS
0x0007 2 0 R_ERR response for host-to-device non-data FIS
0x0009 2 45558 Transition from drive PhyRdy to drive PhyNRdy
0x000a 2 7 Device-to-host register FISes sent due to a COMRESET
0x000b 2 0 CRC errors within host-to-device FIS
0x000d 2 0 Non-CRC errors within host-to-device FIS