/dev/sda === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint F1 DT Device Model: SAMSUNG HD083GJ Serial Number: -- LU WWN Device Id: 5 0024e9 ... Firmware Version: 1AC01118 User Capacity: 80,026,361,856 bytes [80.0 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7, ATA8-ACS T13/1699-D revision 3b Local Time is: Wed Mar 14 12:48:48 2018 EET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 572) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 10) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 097 097 011 - 1870 4 Start_Stop_Count -O--CK 097 097 000 - 3076 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 7 Seek_Error_Rate POSR-- 100 100 051 - 0 8 Seek_Time_Performance P-S--K 100 100 015 - 0 9 Power_On_Hours -O--CK 099 099 000 - 5907 10 Spin_Retry_Count PO--CK 100 100 051 - 0 11 Calibration_Retry_Count -O--C- 100 100 000 - 0 12 Power_Cycle_Count -O--CK 097 097 000 - 2800 13 Read_Soft_Error_Rate -OSR-- 100 100 000 - 0 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 184 End-to-End_Error PO--CK 100 100 000 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 100 000 - 0 190 Airflow_Temperature_Cel -O---K 069 063 000 - 31 (Min/Max 31/31) 194 Temperature_Celsius -O---K 068 062 000 - 32 (Min/Max 31/32) 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 297469 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O--C- 100 100 000 - 0 198 Offline_Uncorrectable ----CK 100 100 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 100 100 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x04 GPL R/O 2 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 2 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x20 GPL R/O 2 Streaming performance log [OBS-8] 0x21 GPL R/O 1 Write stream error log 0x22 GPL R/O 1 Read stream error log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (2 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 31 Celsius Power Cycle Max Temperature: 32 Celsius Lifetime Max Temperature: 41 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: -4/72 Celsius Min/Max Temperature Limit: -9/77 Celsius Temperature History Size (Index): 128 (102) Index Estimated Time Temperature Celsius 103 2018-03-14 10:41 29 ********** 104 2018-03-14 10:42 30 *********** 105 2018-03-14 10:43 30 *********** 106 2018-03-14 10:44 30 *********** 107 2018-03-14 10:45 29 ********** ... ..( 10 skipped). .. ********** 118 2018-03-14 10:56 29 ********** 119 2018-03-14 10:57 30 *********** 120 2018-03-14 10:58 30 *********** 121 2018-03-14 10:59 30 *********** 122 2018-03-14 11:00 29 ********** ... ..( 12 skipped). .. ********** 7 2018-03-14 11:13 29 ********** 8 2018-03-14 11:14 30 *********** ... ..( 5 skipped). .. *********** 14 2018-03-14 11:20 30 *********** 15 2018-03-14 11:21 29 ********** 16 2018-03-14 11:22 30 *********** 17 2018-03-14 11:23 30 *********** 18 2018-03-14 11:24 29 ********** 19 2018-03-14 11:25 30 *********** ... ..( 14 skipped). .. *********** 34 2018-03-14 11:40 30 *********** 35 2018-03-14 11:41 31 ************ ... ..( 3 skipped). .. ************ 39 2018-03-14 11:45 31 ************ 40 2018-03-14 11:46 30 *********** ... ..( 6 skipped). .. *********** 47 2018-03-14 11:53 30 *********** 48 2018-03-14 11:54 31 ************ 49 2018-03-14 11:55 30 *********** ... ..( 7 skipped). .. *********** 57 2018-03-14 12:03 30 *********** 58 2018-03-14 12:04 29 ********** 59 2018-03-14 12:05 30 *********** 60 2018-03-14 12:06 29 ********** 61 2018-03-14 12:07 30 *********** 62 2018-03-14 12:08 30 *********** 63 2018-03-14 12:09 19 - 64 2018-03-14 12:10 20 * 65 2018-03-14 12:11 21 ** 66 2018-03-14 12:12 21 ** 67 2018-03-14 12:13 22 *** 68 2018-03-14 12:14 22 *** 69 2018-03-14 12:15 23 **** 70 2018-03-14 12:16 23 **** 71 2018-03-14 12:17 24 ***** 72 2018-03-14 12:18 24 ***** 73 2018-03-14 12:19 25 ****** 74 2018-03-14 12:20 25 ****** 75 2018-03-14 12:21 25 ****** 76 2018-03-14 12:22 26 ******* 77 2018-03-14 12:23 26 ******* 78 2018-03-14 12:24 27 ******** 79 2018-03-14 12:25 27 ******** 80 2018-03-14 12:26 28 ********* ... ..( 2 skipped). .. ********* 83 2018-03-14 12:29 28 ********* 84 2018-03-14 12:30 29 ********** 85 2018-03-14 12:31 30 *********** 86 2018-03-14 12:32 30 *********** 87 2018-03-14 12:33 30 *********** 88 2018-03-14 12:34 31 ************ ... ..( 2 skipped). .. ************ 91 2018-03-14 12:37 31 ************ 92 2018-03-14 12:38 32 ************* ... ..( 8 skipped). .. ************* 101 2018-03-14 12:47 32 ************* 102 2018-03-14 12:48 31 ************ SCT Error Recovery Control: Read: Disabled Write: Disabled ATA_READ_LOG_EXT (addr=0x04:0x00, page=0, n=1) failed: scsi error badly formed scsi parameters Read Device Statistics page 0x00 failed SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC