/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Blue Mobile Device Model: WDC WD5000LPVT-16G33T0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 500 107 862 016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 3.0, 3.0 Gb/s (current: 3.0 Gb/s) Local Time is: Mon Mar 23 16:01:35 2020 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 96 (intermediate level with standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 8580) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 96) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x70b5) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 156 149 021 - 1191 4 Start_Stop_Count -O--CK 065 065 000 - 35645 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 085 085 000 - 11144 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 096 096 000 - 4864 191 G-Sense_Error_Rate -O--CK 097 097 000 - 3 192 Power-Off_Retract_Count -O--CK 200 200 000 - 118 193 Load_Cycle_Count -O--CK 056 056 000 - 434347 194 Temperature_Celsius -O---K 107 096 000 - 36 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 200 200 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 36 Celsius Power Cycle Min/Max Temperature: 36/36 Celsius Lifetime Min/Max Temperature: 30/47 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (117) Index Estimated Time Temperature Celsius 118 2020-03-23 13:54 37 ****************** 119 2020-03-23 13:55 38 ******************* 120 2020-03-23 13:56 38 ******************* 121 2020-03-23 13:57 39 ******************** 122 2020-03-23 13:58 39 ******************** 123 2020-03-23 13:59 40 ********************* 124 2020-03-23 14:00 39 ******************** 125 2020-03-23 14:01 39 ******************** 126 2020-03-23 14:02 39 ******************** 127 2020-03-23 14:03 40 ********************* ... ..( 3 skipped). .. ********************* 3 2020-03-23 14:07 40 ********************* 4 2020-03-23 14:08 39 ******************** ... ..( 3 skipped). .. ******************** 8 2020-03-23 14:12 39 ******************** 9 2020-03-23 14:13 38 ******************* ... ..( 2 skipped). .. ******************* 12 2020-03-23 14:16 38 ******************* 13 2020-03-23 14:17 ? - 14 2020-03-23 14:18 37 ****************** 15 2020-03-23 14:19 37 ****************** 16 2020-03-23 14:20 ? - 17 2020-03-23 14:21 37 ****************** 18 2020-03-23 14:22 37 ****************** 19 2020-03-23 14:23 36 ***************** 20 2020-03-23 14:24 ? - 21 2020-03-23 14:25 36 ***************** 22 2020-03-23 14:26 36 ***************** 23 2020-03-23 14:27 37 ****************** 24 2020-03-23 14:28 38 ******************* ... ..( 2 skipped). .. ******************* 27 2020-03-23 14:31 38 ******************* 28 2020-03-23 14:32 39 ******************** 29 2020-03-23 14:33 ? - 30 2020-03-23 14:34 40 ********************* 31 2020-03-23 14:35 ? - 32 2020-03-23 14:36 39 ******************** ... ..( 6 skipped). .. ******************** 39 2020-03-23 14:43 39 ******************** 40 2020-03-23 14:44 40 ********************* 41 2020-03-23 14:45 39 ******************** 42 2020-03-23 14:46 39 ******************** 43 2020-03-23 14:47 39 ******************** 44 2020-03-23 14:48 38 ******************* 45 2020-03-23 14:49 38 ******************* 46 2020-03-23 14:50 39 ******************** 47 2020-03-23 14:51 ? - 48 2020-03-23 14:52 38 ******************* ... ..( 12 skipped). .. ******************* 61 2020-03-23 15:05 38 ******************* 62 2020-03-23 15:06 37 ****************** ... ..( 6 skipped). .. ****************** 69 2020-03-23 15:13 37 ****************** 70 2020-03-23 15:14 36 ***************** ... ..( 31 skipped). .. ***************** 102 2020-03-23 15:46 36 ***************** 103 2020-03-23 15:47 ? - 104 2020-03-23 15:48 36 ***************** 105 2020-03-23 15:49 36 ***************** 106 2020-03-23 15:50 37 ****************** ... ..( 3 skipped). .. ****************** 110 2020-03-23 15:54 37 ****************** 111 2020-03-23 15:55 ? - 112 2020-03-23 15:56 36 ***************** ... ..( 2 skipped). .. ***************** 115 2020-03-23 15:59 36 ***************** 116 2020-03-23 16:00 ? - 117 2020-03-23 16:01 36 ***************** SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 5 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 203 Vendor specific