/dev/sda === START OF INFORMATION SECTION === Model Family: Hitachi Deskstar 7K160 Device Model: Hitachi HDS721680PLA380 Serial Number: -- Firmware Version: P21OABBA User Capacity: 80,032,038,912 bytes [80.0 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 1 Local Time is: Sun Apr 22 11:18:36 2018 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 1445) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 24) minutes. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 094 094 016 - 589838 2 Throughput_Performance P-S--- 100 100 050 - 0 3 Spin_Up_Time POS--- 121 121 024 - 165 (Average 165) 4 Start_Stop_Count -O--C- 098 098 000 - 10594 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 5 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 020 - 28 9 Power_On_Hours -O--C- 097 097 000 - 25146 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 9303 192 Power-Off_Retract_Count -O--CK 092 092 000 - 10709 193 Load_Cycle_Count -O--C- 092 092 000 - 10709 194 Temperature_Celsius -O---- 157 157 000 - 38 (Min/Max 9/60) 196 Reallocated_Event_Count -O--CK 100 100 000 - 5 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 253 000 - 247 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log Version: 1 (1 sectors) Device Error Count: 42 (device log contains only the most recent 4 errors) CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 42 [1] occurred at disk power-on lifetime: 17996 hours (749 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 02 00 00 00 e2 cb 45 e0 00 Error: ICRC, ABRT at LBA = 0x00e2cb45 = 14863173 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- ca 00 00 00 00 e2 ca 46 e2 ca 47 e0 00 05:27:29.200 WRITE DMA ca 00 00 00 00 e2 c9 46 e2 c9 47 e0 00 05:27:29.200 WRITE DMA ca 00 00 00 00 00 00 00 e2 c8 47 e0 00 05:27:29.200 WRITE DMA e7 00 00 00 00 5b f8 f6 00 00 00 a0 00 05:27:29.100 FLUSH CACHE ca 00 00 00 08 5c 69 9e 5b f8 ef e0 00 05:27:29.100 WRITE DMA Error 41 [0] occurred at disk power-on lifetime: 17996 hours (749 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 00 00 00 00 2d e5 5e e0 00 Error: ICRC, ABRT at LBA = 0x002de55e = 3007838 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- c8 00 00 c8 08 01 38 ef 2d e5 57 e0 00 05:09:19.800 READ DMA c5 00 00 88 c8 01 39 2f 01 38 ef e0 00 05:09:19.800 WRITE MULTIPLE ca 00 00 00 c8 01 38 c6 01 38 ef e0 00 05:09:19.800 WRITE DMA ca 00 00 00 08 01 38 a6 01 38 bf e0 00 05:09:19.800 WRITE DMA ca 00 00 00 18 2e 34 86 01 38 8f e0 00 05:09:19.800 WRITE DMA Error 40 [3] occurred at disk power-on lifetime: 17996 hours (749 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 88 c8 01 39 2f 01 38 ef e0 00 Error: ABRT at LBA = 0x1392f0138ef = 1345113372911 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- c5 00 00 88 c8 01 39 2f 01 38 ef e0 00 05:09:19.800 WRITE MULTIPLE ca 00 00 00 c8 01 38 c6 01 38 ef e0 00 05:09:19.800 WRITE DMA ca 00 00 00 08 01 38 a6 01 38 bf e0 00 05:09:19.800 WRITE DMA ca 00 00 00 18 2e 34 86 01 38 8f e0 00 05:09:19.800 WRITE DMA c8 00 00 00 40 01 38 7e 2e 34 47 e0 00 05:09:19.700 READ DMA Error 39 [2] occurred at disk power-on lifetime: 17996 hours (749 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 84 -- 51 00 88 00 00 00 01 39 2f e0 00 Error: ICRC, ABRT at LBA = 0x0001392f = 80175 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- ca 00 00 00 c8 01 38 c6 01 38 ef e0 00 05:09:19.800 WRITE DMA ca 00 00 00 08 01 38 a6 01 38 bf e0 00 05:09:19.800 WRITE DMA ca 00 00 00 18 2e 34 86 01 38 8f e0 00 05:09:19.800 WRITE DMA c8 00 00 00 40 01 38 7e 2e 34 47 e0 00 05:09:19.700 READ DMA ca 00 00 00 08 01 38 66 01 38 77 e0 00 05:09:19.700 WRITE DMA SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Commands not supported Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS