/dev/sda === START OF INFORMATION SECTION === Device Model: HGST HTS545050A7E680 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: GG2OAF10 User Capacity: 500 107 862 016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 2.6, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Sat May 28 18:12:35 2016 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 1 (minimum power consumption with standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 112) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 247 247 033 - 0 4 Start_Stop_Count -O--C- 099 099 000 - 2597 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 094 094 000 - 2996 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 654 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 65536 192 Power-Off_Retract_Count -O--CK 100 100 000 - 10 193 Load_Cycle_Count -O--C- 099 099 000 - 19562 194 Temperature_Celsius -O---- 181 181 000 - 33 (Min/Max 18/42) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 33 Celsius Power Cycle Min/Max Temperature: 32/37 Celsius Lifetime Min/Max Temperature: 18/42 Celsius Lifetime Average Temperature: 32 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (88) Index Estimated Time Temperature Celsius 89 2016-05-28 16:05 37 ****************** ... ..( 2 skipped). .. ****************** 92 2016-05-28 16:08 37 ****************** 93 2016-05-28 16:09 36 ***************** 94 2016-05-28 16:10 36 ***************** 95 2016-05-28 16:11 35 **************** ... ..( 5 skipped). .. **************** 101 2016-05-28 16:17 35 **************** 102 2016-05-28 16:18 36 ***************** ... ..( 2 skipped). .. ***************** 105 2016-05-28 16:21 36 ***************** 106 2016-05-28 16:22 35 **************** 107 2016-05-28 16:23 36 ***************** 108 2016-05-28 16:24 36 ***************** 109 2016-05-28 16:25 35 **************** ... ..( 5 skipped). .. **************** 115 2016-05-28 16:31 35 **************** 116 2016-05-28 16:32 36 ***************** 117 2016-05-28 16:33 36 ***************** 118 2016-05-28 16:34 36 ***************** 119 2016-05-28 16:35 35 **************** 120 2016-05-28 16:36 35 **************** 121 2016-05-28 16:37 36 ***************** 122 2016-05-28 16:38 36 ***************** 123 2016-05-28 16:39 36 ***************** 124 2016-05-28 16:40 37 ****************** 125 2016-05-28 16:41 37 ****************** 126 2016-05-28 16:42 36 ***************** ... ..( 4 skipped). .. ***************** 3 2016-05-28 16:47 36 ***************** 4 2016-05-28 16:48 35 **************** 5 2016-05-28 16:49 35 **************** 6 2016-05-28 16:50 36 ***************** ... ..( 2 skipped). .. ***************** 9 2016-05-28 16:53 36 ***************** 10 2016-05-28 16:54 37 ****************** 11 2016-05-28 16:55 37 ****************** 12 2016-05-28 16:56 36 ***************** 13 2016-05-28 16:57 36 ***************** 14 2016-05-28 16:58 35 **************** 15 2016-05-28 16:59 35 **************** 16 2016-05-28 17:00 35 **************** 17 2016-05-28 17:01 34 *************** ... ..( 4 skipped). .. *************** 22 2016-05-28 17:06 34 *************** 23 2016-05-28 17:07 33 ************** ... ..( 8 skipped). .. ************** 32 2016-05-28 17:16 33 ************** 33 2016-05-28 17:17 32 ************* 34 2016-05-28 17:18 33 ************** ... ..( 3 skipped). .. ************** 38 2016-05-28 17:22 33 ************** 39 2016-05-28 17:23 32 ************* 40 2016-05-28 17:24 33 ************** 41 2016-05-28 17:25 32 ************* ... ..( 2 skipped). .. ************* 44 2016-05-28 17:28 32 ************* 45 2016-05-28 17:29 33 ************** 46 2016-05-28 17:30 33 ************** 47 2016-05-28 17:31 32 ************* ... ..( 27 skipped). .. ************* 75 2016-05-28 17:59 32 ************* 76 2016-05-28 18:00 33 ************** ... ..( 11 skipped). .. ************** 88 2016-05-28 18:12 33 ************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 10 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 9 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS