/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Blue Device Model: WDC WD5000LPCX-22VHAT0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Jul 26 19:29:17 2023 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 8220) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 95) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 147 143 021 - 1633 4 Start_Stop_Count -O--CK 100 100 000 - 940 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 097 097 000 - 2891 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 141 192 Power-Off_Retract_Count -O--CK 200 200 000 - 46 193 Load_Cycle_Count -O--CK 199 199 000 - 3377 194 Temperature_Celsius -O---K 109 097 000 - 34 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 100 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb6 GPL,SL VS 1 Device vendor specific log 0xb7 GPL,SL VS 48 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 34 Celsius Power Cycle Min/Max Temperature: 28/35 Celsius Lifetime Min/Max Temperature: 20/47 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (4) Index Estimated Time Temperature Celsius 5 2023-07-26 17:22 46 *************************** ... ..( 7 skipped). .. *************************** 13 2023-07-26 17:30 46 *************************** 14 2023-07-26 17:31 47 **************************** 15 2023-07-26 17:32 46 *************************** ... ..( 9 skipped). .. *************************** 25 2023-07-26 17:42 46 *************************** 26 2023-07-26 17:43 ? - 27 2023-07-26 17:44 25 ****** 28 2023-07-26 17:45 26 ******* 29 2023-07-26 17:46 27 ******** 30 2023-07-26 17:47 27 ******** 31 2023-07-26 17:48 27 ******** 32 2023-07-26 17:49 28 ********* 33 2023-07-26 17:50 29 ********** 34 2023-07-26 17:51 30 *********** 35 2023-07-26 17:52 ? - 36 2023-07-26 17:53 31 ************ 37 2023-07-26 17:54 31 ************ 38 2023-07-26 17:55 32 ************* 39 2023-07-26 17:56 33 ************** 40 2023-07-26 17:57 ? - 41 2023-07-26 17:58 33 ************** 42 2023-07-26 17:59 34 *************** 43 2023-07-26 18:00 35 **************** 44 2023-07-26 18:01 35 **************** 45 2023-07-26 18:02 ? - 46 2023-07-26 18:03 26 ******* 47 2023-07-26 18:04 26 ******* 48 2023-07-26 18:05 27 ******** 49 2023-07-26 18:06 ? - 50 2023-07-26 18:07 27 ******** 51 2023-07-26 18:08 30 *********** 52 2023-07-26 18:09 32 ************* 53 2023-07-26 18:10 ? - 54 2023-07-26 18:11 28 ********* 55 2023-07-26 18:12 28 ********* 56 2023-07-26 18:13 29 ********** 57 2023-07-26 18:14 ? - 58 2023-07-26 18:15 27 ******** 59 2023-07-26 18:16 28 ********* ... ..( 6 skipped). .. ********* 66 2023-07-26 18:23 28 ********* 67 2023-07-26 18:24 ? - 68 2023-07-26 18:25 28 ********* 69 2023-07-26 18:26 ? - 70 2023-07-26 18:27 28 ********* 71 2023-07-26 18:28 ? - 72 2023-07-26 18:29 28 ********* ... ..( 2 skipped). .. ********* 75 2023-07-26 18:32 28 ********* 76 2023-07-26 18:33 29 ********** 77 2023-07-26 18:34 30 *********** 78 2023-07-26 18:35 30 *********** 79 2023-07-26 18:36 31 ************ ... ..( 8 skipped). .. ************ 88 2023-07-26 18:45 31 ************ 89 2023-07-26 18:46 30 *********** ... ..( 5 skipped). .. *********** 95 2023-07-26 18:52 30 *********** 96 2023-07-26 18:53 31 ************ ... ..( 13 skipped). .. ************ 110 2023-07-26 19:07 31 ************ 111 2023-07-26 19:08 32 ************* 112 2023-07-26 19:09 32 ************* 113 2023-07-26 19:10 33 ************** ... ..( 6 skipped). .. ************** 120 2023-07-26 19:17 33 ************** 121 2023-07-26 19:18 34 *************** ... ..( 7 skipped). .. *************** 1 2023-07-26 19:26 34 *************** 2 2023-07-26 19:27 35 **************** 3 2023-07-26 19:28 34 *************** 4 2023-07-26 19:29 34 *************** SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 5 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 3753 Vendor specific