/dev/sda smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-48-generic] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: HGST Travelstar 7K1000 Device Model: HGST HTS721010A9E630 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: JB0OA3J0 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 6 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Sat Sep 26 12:27:40 2020 +03 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 45) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 167) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 062 - 0 2 Throughput_Performance P-S--- 100 100 040 - 0 3 Spin_Up_Time POS--- 125 125 033 - 2 4 Start_Stop_Count -O--C- 090 090 000 - 16948 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 040 - 0 9 Power_On_Hours -O--C- 069 069 000 - 13818 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 096 096 000 - 7764 191 G-Sense_Error_Rate -O-R-- 100 100 000 - 0 192 Power-Off_Retract_Count -O--CK 100 100 000 - 118 193 Load_Cycle_Count -O--C- 067 067 000 - 331935 194 Temperature_Celsius -O---- 193 193 000 - 31 (Min/Max 12/47) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 200 000 - 0 223 Load_Retry_Count -O-R-- 100 100 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 3076 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 31 Celsius Power Cycle Min/Max Temperature: 26/31 Celsius Lifetime Min/Max Temperature: 12/47 Celsius Specified Max Operating Temperature: 33 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (124) Index Estimated Time Temperature Celsius 125 2020-09-26 10:20 37 ****************** ... ..( 6 skipped). .. ****************** 4 2020-09-26 10:27 37 ****************** 5 2020-09-26 10:28 36 ***************** 6 2020-09-26 10:29 37 ****************** ... ..( 14 skipped). .. ****************** 21 2020-09-26 10:44 37 ****************** 22 2020-09-26 10:45 ? - 23 2020-09-26 10:46 24 ***** 24 2020-09-26 10:47 25 ****** 25 2020-09-26 10:48 26 ******* 26 2020-09-26 10:49 27 ******** 27 2020-09-26 10:50 27 ******** 28 2020-09-26 10:51 28 ********* 29 2020-09-26 10:52 29 ********** 30 2020-09-26 10:53 29 ********** 31 2020-09-26 10:54 30 *********** 32 2020-09-26 10:55 29 ********** 33 2020-09-26 10:56 30 *********** 34 2020-09-26 10:57 30 *********** 35 2020-09-26 10:58 31 ************ ... ..( 3 skipped). .. ************ 39 2020-09-26 11:02 31 ************ 40 2020-09-26 11:03 32 ************* ... ..( 2 skipped). .. ************* 43 2020-09-26 11:06 32 ************* 44 2020-09-26 11:07 33 ************** 45 2020-09-26 11:08 34 *************** 46 2020-09-26 11:09 33 ************** 47 2020-09-26 11:10 33 ************** 48 2020-09-26 11:11 33 ************** 49 2020-09-26 11:12 34 *************** ... ..( 16 skipped). .. *************** 66 2020-09-26 11:29 34 *************** 67 2020-09-26 11:30 35 **************** 68 2020-09-26 11:31 34 *************** ... ..( 2 skipped). .. *************** 71 2020-09-26 11:34 34 *************** 72 2020-09-26 11:35 35 **************** 73 2020-09-26 11:36 35 **************** 74 2020-09-26 11:37 34 *************** 75 2020-09-26 11:38 34 *************** 76 2020-09-26 11:39 35 **************** ... ..( 23 skipped). .. **************** 100 2020-09-26 12:03 35 **************** 101 2020-09-26 12:04 36 ***************** 102 2020-09-26 12:05 35 **************** 103 2020-09-26 12:06 36 ***************** 104 2020-09-26 12:07 35 **************** 105 2020-09-26 12:08 36 ***************** 106 2020-09-26 12:09 35 **************** 107 2020-09-26 12:10 36 ***************** 108 2020-09-26 12:11 35 **************** 109 2020-09-26 12:12 36 ***************** ... ..( 5 skipped). .. ***************** 115 2020-09-26 12:18 36 ***************** 116 2020-09-26 12:19 ? - 117 2020-09-26 12:20 26 ******* 118 2020-09-26 12:21 27 ******** 119 2020-09-26 12:22 27 ******** 120 2020-09-26 12:23 28 ********* 121 2020-09-26 12:24 28 ********* 122 2020-09-26 12:25 29 ********** 123 2020-09-26 12:26 30 *********** 124 2020-09-26 12:27 30 *********** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0009 2 5793 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS